2 Photos Below, Peel the black tape off, the 2 cables you see in these photos you do not have to remove.
Next photo below, iPad 2 wifi cable now dis-connected from board, the antenna cable runs under corel draw 9 with crack a wider black power connector cable leading to the logic board area.
Virtual Private Network (VPN) Private Internet Access.The power ribbon cable is one cable that handles powering accelerator plus for mac cracked iPad on, crysis 3 keygen skidrow off, sleep, volume, mute functions.Located on the right side between the iPads Home button and right corner as if you are holding the iPad in front of you.Trouble is once you get by, free up digitizer on one antenna, you have a second one to free up, get by on other side of camera.The other morning, Im in a coffee shop.Silver cover popped off, and removed.I thought the iPad 2 logic board was going to have to be removed, but there is a much easier way without having to remove the logic board.With a small tool, carefully, very carefully pop it slowly upwards, straight.Make sure the very small 4 screws are back in place that anchor antenna to the iPads frame.So at that low cost it is a good idea to order one if you intend on repairing your front panel touch screen digitizer.This time, I hit paydirt.
February 25, 2012 mvm saikrishna, fix, Tutorial, fix Obtaining IP Address Android WiFi Problem.
I moderate for spam, relevance, and abuse but, aside from that, this is an open forum.
5) Close the window and relax.
You might not hear a click.
First iPad with cellular antennas I ripped out and had to replace the cell antennas, have done 300 iPads since, never ripped one out again.Both these Cellular Data Antennas are also glued by strong adhesive tape to the backside of the iPads digitizer.Best yet keep a few extra around especially if you are doing these type repairs for customers.Signal strength might be weak or not work at all.Line the silver cover back up, and carefully push and snap silver cover back down.The frame backing on the iPads with Cellular Data Antennas is black plastic or hard rubber directly behind the antennas.Run or route the new iPad 2 wireless wifi cable under the silver trim (last photo).(Back about 4-5 photos above) Run the wifi cable back over to the Home button area.And here is the other end of the wireless cable.For future repairs, knowing the location, applying enough heat, prying up slowly to get a peak under the digitizer in this area, and being very careful in this area is the key to removing digitizer without ripping the wifi antenna out.